Journal · Production · 09/11/2026
From −18 °C to 71 °C: Our Surface Passes an Extreme Temperature Change Test
Two samples of our printed stone-grain cement surface spent 24 hours at −18 °C, then 24 hours at 71 °C. Eurofins found no yellowing, cracking or damage.

A table top made of cement, print and protective coating is really three layers working together. When temperature swings hard, each layer expands and shrinks at its own rate — and that is where cracks and yellowing usually start. So we asked an independent lab to test exactly that.


The test
Eurofins Consumer Product Testing Vietnam ran its Effects of Extreme Temperature Change method (ERF-HLITM-0018) on two samples of our printed stone-grain cement surface:
- 24 hours at 0 °F (−18 °C)
- then 24 hours at 160 °F (71 °C)
- requirement: no yellowing, cracking or damage
The result
Pass on both samples — no yellowing, no cracks and no damage after testing (report EFUZ26094739-CG-01 Revised 1, issued 6 October 2026 and revised 9 October 2026).
Why these temperatures matter
Heat: a surface left in direct summer sun gets far hotter than the air around it, and heat is also what turns many clear coatings yellow. Holding up at 71 °C without yellowing is a meaningful check for terraces, rooftop restaurants, pool decks and other sun-exposed spaces in hot climates.
Cold: −18 °C covers hard winters, furniture shipped in the cold season and pieces stored in unheated warehouses before they reach the customer.
Going straight from deep cold to high heat is a harder test than either temperature alone, because the layers have to move together without separating.
What we did not test
This test is one cold period followed by one hot period. It is not a repeated freeze–thaw test with water soaked into the material. For projects where pieces will stay outdoors through frost, talk to us — we will advise on placement and covers and can arrange additional testing. The result applies to the samples tested, and our products carry a 2-year warranty.
Read the report summary on our Quality & Compliance page, or ask for a quotation for your project.



